|
|
|
|
Show tree protection details. Show tree protection for all trees to be retained in the project vicinity.
- Provide detail for screening wall for accessory structures
- Parking spaces (4) along Glen Meade Rd do not meet dimensional requirements (8.5’ x 18’ standard, 8’ x 16’ compact).
- Provide copy of shared parking agreement with NHRMC.
- Provide landscape plan.
- A tree removal permit is required. If no trees are being removed please indicate on permit.
NHRMC WOUND CARE PARKING LOT [TRC Plan Review #2]
Initial Review Note
All comments are based on adopted policy documents, specific City of Wilmington Land Development Code (CofW LDC) and City of Wilmington Technical Standards and Specifications Manual (CofWTSSM) requirements in effect at the time of this review. These have been noted after the comment as appropriate for your ease in further research. The City Engineer may administratively approve dimensional variance requests per LDC Sec. 18-348. If the Applicant feels further interpretation is in order, please contact Transportation Planning directly to discuss in additional detail. Please apply for all administrative variances in writing, an email is acceptable or this may be included on the plan set. Please see Sec. 18-348 of the Land Development Code for the information required to process a variance request.
NCDOT:
It is the Applicant’s responsibility to coordinate directly with NCDOT to determine if any driveway permits/ revisions/ review processes are required. Contact NCDOT at 910. 251.2655. Please note additional comments may be forthcoming once coordination occurs.
TECHNICAL STANDARDS – DRIVEWAY ACCESS (Major Thoroughfares):
1. When the lot has sufficient frontage, driveways for corner lots along major thoroughfares must have corner clearance of 230’ as measured along the curb line. A variance may be requested for this driveway location.
TECHNICAL STANDARDS – ACCESS (driveway, sidewalk, and sight distance):
2. The Glen Meade Road driveway does not appear to intersect at a 90 degree angle. Please revise. [7-11 #3 CofW Tech Stds]
3. Please ensure the driveways meet City-standard ramp-type driveways. Show appropriate City standard detail(s) on plan. [Chapter VII ,Detail SD 3-03 CofWTSSM]
4. Dimension driveway widths and tapers. [Sec.18-529 CofW LDC]
5. Provide a sidewalk connection between the site and the public sidewalk.
6. The site plans have shown a 4’ sidewalk adjacent to the new tank and vaporizer pad. Please increase to a standard 5’ sidewalk width. If the sidewalk will be at the back of curb, install a 6’ sidewalk per Technical Standards.
7. Show and apply the City’s 20’x70’ sight distance triangle at each driveway on the site plan and landscaping plan. [Sec.18-529(c)(3)CofW LDC] Add a note indicating that all proposed vegetation within sight triangles shall not interfere with clear visual sight lines from 30"-10'. [Sec.18-566 CofW LDC]
TECHNICAL STANDARDS – PARKING:
8. Please label the dimensions for the proposed parking aisle behind the new handicap parking space and adjacent parking space, (located at the west side of the building). Twenty-four feet (24’) is the minimum drive aisle width behind perpendicular parking. [Chapter VII, Table 6, pg. 7-19 CofWTSSM]
9. The parking lot has proposed flush curbing at the northern side of the building. Please provide protection to prevent vehicles from encroaching upon this sidewalk.
10. The proposed 24” curb and gutter sections (flow-line and spill-off) do not match city standard details for 24” curb and gutter. 12” of ABC stone must extend beyond the curb and gutter. [Detail SD 3-11 CofWTSSM] Please revise.
11. The backing stub adjacent to the Handicap Van Accessible parking space is to be 10’ deep by 15’ wide. Please increase the backing stub to the required dimension. [Chapter VII ,Detail SD 15-12 CofWTSSM]
12. Please show the location of the proposed bicycle parking on the plans. [Sec.18-528 CofW LDC]
TECHNICAL STANDARDS – Barrier Free Design:
13. The proposed handicap ramp does not meet technical standards for handicap (curb) ramps adjacent to a plaza. Revise the curb ramp to match SD 3-08. A ramp and 5’ landing area must be installed. [Detail SD 3-08 CofWTSSM] Provide standard detail for SD 3-08 on the plan
GENERAL NOTES TO ADD TO THE PLAN:
A. Immediately notify City of Wilmington Traffic Engineering at 910-341-7888 if any traffic signal facilities or City-Owned streetlight facilities are damaged.
B. Damaged facilities shall be replaced, by an approved contractor, according to standard NCDOT replacement schedules and current NCDOT design standards.
C. All repair/replacement of traffic signal infrastructure shall be coordinated with the City of Wilmington Traffic Engineering Division.
Please let me know if you have any questions or if I can be of further assistance as this development moves through the review process.
|